pegoil1-a010009.jpg
pegoil1-a010005.jpg
1
pegoil1-a010001.jpg
pegoil1-a010002.jpg pegoil1-a010003.jpg
pegoil1-a010004.jpg
2
Set your thermostat to heat mode and set desired temp higher than room temperature.
3
If your furnace has 2 copper tubes (slightly larger than a pencil) running from the tank, then all you need to do is press the red reset button on the burner control. The burner control is usually located on the burner chassis, although on some older furnaces it may be located on the chimney connector pipe. If the burner cuts off after about 30 seconds, wait 1 minute and press the red reset button only once more! If the burner still won't continue to run, call for service. Don't press the reset button more than 2 times!
pegoil1-a010008.gif
VIEW
BURNER
CONTROLS
pegoil1-a010006.gif
If your furnace only has 1 copper tube running from the tank,
it is recommended you call an HVAC tech. For educational procedure on fuel unit priming, click next:
pegoil1-a010007.gif